handi quilter Avante QM30235, Руководство пользователя

Страница: 8 / 40

Page 8
HQ
18
Avanté User Manual
Note: After the handles have been completely installed and plugged in, test them by turning the HQ
18
Avanté on/
off switch to “on”. If nothing is displayed, check that the handlebar cable on the side of the machine is plugged
in securely, that your machine is turned on, and that the power cord is plugged into the machine as well as a
power source.
Caution: Unplug the HQ
18
Avanté from the electrical
outlet. All power to the machine must be turned off
when installing the front handles. Failure to do so
can result in damage to the machine.
Locate the three long bolts and the 5mm Hex
wrench. To install the handlebar,line up the holes on
top of the handles with the pre-drilled holes on top
of the machine. Slide a single bolt into one of the
holes until it stops. Hand-tighten the bolt enough to
secure the handles to the top of the machine. Insert
and hand-tighten the remaining two handlebar bolts.
Use the included 5 mm Hex wrench to securely fas-
ten the handles to the front of the machine.
Once the bolts are in place, plug the 9-pin connector
into the serial port located on the left-hand side of
the machine (see Figure 2, #18, page 6). Ensure the
pins are lined up so they are not damaged when the
plug is pushed in. Push the plug securely in place.
Installing Front Handlebars
Check that the HQ
18
Avanté is unplugged from the
electrical outlet. All power to the machine must
be turned off when installing the back handlebar.
Failure to do so can result in damage to the machine.
The rear handle bar comes mounted with three
screws to the “L” bracket. Line up the two holes
in the “L” bracket with those on the rear of the
machine. Slide the short bolts into holes until they
stop. Hand tighten, and then use the 5mm wrench
to securely fasten the handles to the back of the
machine.
Once the two bolts are in place, plug the 9-pin
connector into the serial port underneath the rear
handles. Ensure the pins are lined up so they are not
damaged when the plug is pushed in. Push the plug
securely in place.
Installing Rear Handlebars
Insert the cord into top power connector on the rear
of the machine. Plug the three-prong end into a
power source (see Figure 6).
The lower power connector is for powering other
attachments developed by Handi Quilter. (Not yet
available)
Installing the Power Cord
Figure 6