Hand Held Products SCANTEAM 2070 BASE, Руководство пользователя

Страница: 22 / 132

Cordless System Manual
1–12
Replacing Battery Pack While Associated
When you insert the battery pack, the scanner beeps, followed by clicking.
During this period the work group parameter table is uploaded to the scanner
from the base. Scanning and data transmission is interrupted. When the
scanner emits a second beep, you may scan again. If you don’t receive a second
beep, the table was not transferred successfully either because the scanner was
out of range or all of the data was not received. Scan the association label again.
Moving Scanners From One Base to Another
Swapping Scanners Between Two Systems with Nine Scanners on Each
You may transfer a scanner between base networks by scanning a new base
association label. Scanners can only be associated to one base at a time. Once
a scanner has been associated to a base, it tries to stay associated to that base
until a new base association label has been scanned. The new base adds a
scanner to its association list as long as fewer than nine scanners are in its
network. If a base has nine scanners in its network, you need to disassociate
one scanner before adding another (see next section).
You may use the Remove Scanner Selection (page 4–3) to disassociate any
scanner and then add a new scanner by scanning the association label with the
new scanner. If you cannot scan the disassociation label because the scanner
you are trying to disassociate was damaged, remove power from that scanner
and it automatically disassociates in approximately three seconds.
Glossary
Base Reset Conditions
Reassociation
Association List
The base resets when base power is lost or when a diagnostic problem is
sensed. In either case, the scanners automatically reassociate, if they are within
range.
The process of uploading the work group parameter table from the base is called
“reassociation.” During reassociation, the scanner clicks, then beeps once.
Reassociation is done automatically, without having to scan an association label.
The base keeps an association list of up to nine entries. This list maintains the
associated scanners’ radio serial numbers and dynamic addresses. New
dynamic addresses are assigned to the scanners each time a Base Reset
occurs. This helps the Cordless System track the status of the different scanners
in its network during the association and reassociation process.