Hand Held Products Dolphin 9550, Руководство пользователя

Страница: 212 / 248

11 - 6 Dolphin® 9500/9550 Mobile Computer User’s Guide
Locking Tabs
When positioned as shown in the above graphic, the locking tabs secure the spring arm assembly, latch, and terminal
in place. When seating a terminal, turn both arms up to allow the spring arm to move as necessary while the terminal
is being inserted. After the terminal is seated, turn both arms toward the center to lock them.
The both locking tabs must be pointing up to insert or remove a terminal in the Mobile Base.
Spring Arm Assembly
The spring arm assembly is the column that connects the latch to the back of the Mobile Base.
Ball Joints
There are two ball joints: one on the back of the Mobile Base and one on the mounting bracket. Both ball joints are
inserted into the bracket and secured to mount the Mobile Base.
Connectors
The power and RS-232 connectors are located on the bottom panel. For more information, see Bottom Panel on page
11-3.
Brackets
Bracket
The bracket contains the turnscrew and two slots. Ball joints are inserted into each slot and secured with the turnscrew.
Turnscrew
The turnscrew is located on the top of the bracket. Rotate the turnscrew to secure or loosen the ball joint slots.
Mounting Bracket
The mounting bracket is what you attach to the mounting surface. It is comprised of a ball joint and flat disk. The disk
contains drill holes you use to secure the Mobile Base to the mounting surface.
Powering the Dolphin Mobile Base
Note: HHP recommends that you leave the Mobile Base connected to its power source at all times.
The Mobile Base is powered via the power connector on the bottom panel; see Bottom Panel on page 11-3 . Both the power and
serial connectors are straight out, not at an angle.
The Mobile Base must be powered by a 12 to 48 volt DC source.