HAMPTON BAY H35U-LP, Инструкция для владельца и по установке

Страница: 38 / 60

38
Hampton® H35U Direct Vent Freestanding Gas Stove
installation
C)02-44
Pins on Rear Log Support
A)02-43
B)02-56
4)
Place Rear Log A)02-43 on the two pins on
the rear log support.
5) Place the Middle Left Log B)02-56 on the
two pins as shown.
6) Sprinkle some lava rock just in front of B)
02-56 on the burner holes.
7) Place Front Left Log C)02-44 onto the 2
front pins as shown.
The bottom right edge of Log G)02-48 must
sit snugly against the bracket. (Front Log
02-45 has been removed so that the bracket
can be seen.)
Notch
A)02-43
G)02-48
E)02-45
F)02-47
12) Position notch in Front Right Log G)02-48
on Log F)02-47 and push the bottom right
edge against the bracket on the burner tray.
Bracket
Side View
G)02-48
13) Test fire to ensure proper light off (make
sure flame flows smoothly from one end
of burner to the other. If there is any flame
hesitation, check that area for any blockage
of the burner port.
F)02-47
E)02-45
A)02-43 G)02-48
D)02-46
B)02-56
C)02-44
8) Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout
on Log A)02-43.
E)02-45
Cutout Pin
D)02-46
B)02-56
A)02-43
C)02-44
9) Place Front Right Log E)02-45 on the two
pins as shown.
10)
Place the lava rock in the area between the
left and right logs, leaving a space in the
middle for log (F) 02-47.
Separate platinum embers and place on and
around the lava rock. Avoid stacking platinum
embers.
Cutout
Notch
F)02-47
E)02-45
A)02-43
11) Place the notch in Center Log F)02-47 over
Log E)02-45 and across the cutout on Log
A)02-43.
lava rock
B)02-56
Double Door Removal
1)
Remove the right door by unfastening the
2 right hinges (2 screws per hinge).
Repeat for the left door.