HAMPTON BAY H35U-LP, Инструкция для владельца и по установке

Страница: 35 / 60

Hampton® H35U Direct Vent Freestanding Gas Stove
35
installation
H35U
1
920-448
02/18/22
Conversion Kit # 744-969 from NG to LPG
for H35U using SIT 820 NOVA Gas Valve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG
Conversion Kit
LPG Conversion Kit contains:
Qty. Part # Description
1 904-529 5/32" Allen Key
1 904-390 Burner Orifice #52
1 918-590 Label "Converted to LPG"
1 908-528 Red "LPG" label
1 910-037 LP Injector (Pilot Orifice)
1
920-448 Instruction Sheet
5) Pull off the
pilot cap to
expose the
pilot orifice.
Remove the 2 screws, push Burner
Assembly to the left and lift out.
Burner Orifice
Installation of LPG
Conversion Kit:
1) Shut off the gas supply.
2) Lift off the cast top and remove the glass
front. Also, open up the control panel door.
3)
Remove the logs, embers, and brick panels
(if used).
4) Remove the 2 screws holding the Burner
Assembly to the firebox base. Push the
Burner Assembly to the left and lift out.
6)
Unscrew the pilot orifice with the Allen key
and replace with the LP pilot orifice in the
kit and replace pilot cap.
7) Remove burner orifice with a 1/2" wrench
and discard. Use another wrench to hold
on to the elbow behind the orifice.
8) Reinstall new burner orifice LP stamped
#52 and tighten.
9
)
Turn control knob to the “OFF” position.
10
) Remove the Hi/Low extension knob by
pulling it towards you. This will expose the
black protection cap. Remove the black
protection cap by hand from the high-low
knob (Fig.1).
Fig. 1
11
) Insert a 5/32” or 4mm Allen wrench into
the hexagonal key-way of the screw (Fig.
2), rotate it counter-clockwise until it is
free and extract it.
12
) Check that the screw is clean and if
necessary remove dirt.
13
) Flip the screw (Fig. 3).
Fig.2
Fig.3
Conversion Kit #744-969 from NG to LP