HAMPTON BAY H35U-LP, Инструкция для владельца и по установке

Страница: 37 / 60

Hampton® H35U Direct Vent Freestanding Gas Stove
37
installation
Log Set Installation
Read the instructions below carefully and refer
to the diagrams. If logs are broken do not use
the unit until they are replaced. Broken logs
can interfere with the pilot operation.
The gas log kit contains the following:
a) 02-43 Rear Log
b)
02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left Top Log
e)
02-45 Front Right Log
f) 02-47 Center Log
g)
02-48 Middle Right Log
h) Embers
i) Lava
j)
Platinum Embers
(supplied with
packaged manual)
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle with
care -
do not force into position.
2)
Lift off the Cast Top and remove the glass front
(refer to the "Glass Replacement" section in
this manual).
3) Sprinkle the embers on the left and right sides
of the firebox base.
A) 02-43 D) 02-46
G) 02-48
C) 02-44 B) 02-56
F) 02-47
E) 02-45
Optional Brick Panel
1) Remove the cast top and glass front (see Glass
Replacement section in this manual for instruc-
tions).
2) Remove the log set if installed.
3)
Insert the back brick panel first by carefully
slipping it between the back wall of the firebox
and the rear log bracket.
Back Panel
Diagram 1
4) Before installing the side brick panels, loosen
the screws for the brick tabs enough so that you
can slide the brick tabs on to the screws easily
but that the tabs are secure. For the location
of the side brick tab screws see Diagram 1.
Brick
tab screw
Back
brick
panel
Side
brick
panel
Diagram 2
5) Put the side panels in next. Slide them in
from the front and push them flat up against
the wall. Be very careful not to scratch them
on the firebox hardware.
Left
Side
Panel
Right
Side
Panel
Brick Tab
Screw
Brick
Tab
6) Install the brick tabs (refer to Diagram 2).
Embers Embers