38
|
Hampton
®
H27-10 Direct Vent Freestanding Gas Stove
|
38
operating instructions
FIRST FIRE
The first fire in your stove is part of the paint curing
process. To ensure that the paint is properly cured,
it is recommended that you burn your fireplace
for at least four (4. hours the first time you use
it with the fan on. When first operated, the unit
will release an odour caused by the curing of the
paint, the burning off of any oils remaining from
manufacturing. Smoke detectors in the house may
go off at this time. Open a few windows to ventilate
the room for a couple of hours.
The glass panel may require cleaning after the unit
has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Note: When the glass is cold and the appliance
is lit, it may cause condensation and fog
the glass. This condensation is normal
and will disappear in a few minutes as
the glass heats up.
OPERATING
INSTRUCTIONS
1.
Read and understand these instructions before
operating this appliance.
2.
Check to see that all wiring is correct and
enclosed to prevent possible shock.
3.
Check to ensure there are no gas leaks.
4.
Make sure the glass in the door frame is properly
positioned. Never operate the appliance with
the glass removed.
5.
Verify that the venting and cap are unobstructed.
6.
Verify log placement. If the pilot cannot be
seen when lighting the unit, the logs have been
incorrectly positioned.
7.
The unit should never be turned off, and on
again without a minimum of a 60 second wait.
During the first few fires, a white film
may develop on the glass front as part
of the curing process. The glass should
be cleaned
or the film will bake on and
become very difficult to remove. Use a
non-abrasive cleaner and NEVER clean
the glass while it is hot.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
8.
Remote control requires coding. See remote
coding instructions for details.
NOTE:
This appliance will operate with 4 AA back-up
batteries installed (see Back-up Battery section
for details) during power outages. Only the fan
and light will not operate until power is restored.
If the remote is misplaced, the unit can be shut
off by flipping the main
ON/OFF
switch, located
behind the front cover plate, to the
OFF
position.
IMPORTANT:
The remote control system supplied
with this appliance has several options for
starting/operating the appliance, please read the
remote control operating instructions (packed
with remote control) to understand how to
operate this remote system. You can download
remote functions video with the QR code below.
