10
Assembly — Close-to-Ceiling Mounting
1
2
3
Assembling the fan
Preparing the motor
Preparing the canopy
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted screws (FF) from the
canopy (C), and loosen the slotted screws (FF) on the
canopy (C).
□
Remove the canopy bottom cover (D) from the
canopy (C) by turning the canopy bottom cover (D)
counterclockwise
.
□
Remove three of the six collar mounting screws with
lock washers (JJ) (every other one) from the collar on
top of the fan motor assembly (G).
□
Route the wires exiting from the top of the fan motor
assembly (G) through the canopy ring (B).
□
Make sure the slot openings are on top, and then
proceed to place the canopy over the collar at the top
of the fan motor assembly.
□
Align the mounting holes in the bottom of the canopy
(C) with the holes in the top of the fan motor assem-
bly (G), and fasten using the three collar mounting
screws with lock washers (JJ) previously removed.
□
Tighten the collar mounting screws (JJ) securely.
WARNING:
Failure to completely tighten the three collar
mounting screws (JJ) could result in the fan becoming loose
and possibly falling.
JJ
G
C
B
G
JJ
A
FF
FF
C
B
D
