Access
window
Blade
Screws
Fiber washers
Figure 14
Outlet box
Hanger
bracket
Hanger
ball
Canopy
Canopy
cover
Figure 15
7. Blade installation
Rotate motor until holes become visible
through the motor access window. Align the
holes from the blade to the holes from the
motor and secure in place with screws and
fiber washers provided.
(Fig. 15)
Fan
White (neutral)
White (neutral)
Green or bare
copper (ground)
White ("AC IN N")
White ("to motor N")
Orange
(for upper light)
Orange
(for upper light)
Ground
(green)
(Connect to
ground wire on
hanger bracket
if no house
ground wire
exists.)
Outlet box
Black (hot)
Black ("AC IN L")
Black ("to motor L")
Receiver
Blue (for bottom light)
Blue (for bottom light)
Black (motor)
Figure 13
6. Finishing the
Installation
Step 1.
Step 2. Slide the canopy up to ceiling and over
the screw on hanger bracket. Rotate canopy
clockwise and tighten the screws. Next, while
holding the canopy with one hand, slide the
canopy cover over the screws and rotate
clockwise until tight.
Note:
adjust the canopy
screws as necessary until the canopy and
canopy cover are snug. (Fig. 14)
Remove 1 of 2 screws from the
hanger bracket.
