STARTING THE ENGINE
NOTICE
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
TIP
The choke is fully on when it’s pulled out. The choke is off when it’s completely
pushed in. The choke can be adjusted gradually depending on how much
choke is needed for starting.
1. Sit in the driver’s seat and fasten the seat belt.
2. Place the transmission in neutral. Set the parking brake.
3. Apply the brakes.
4. If the engine is cold, use full choke by pulling the choke all the way out. A
warm engine will not require the use of the choke.
5. Do not press the throttle pedal while starting the engine.
6.
If operating an LE model:
make sure the Engine Stop Switch is in the ON
position.
7. Turn the ignition key past the ON/RUN position to START. Engage the starter
for a maximum of five seconds. Release the key when the engine starts.
8. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 6 and 7 until the
engine starts.
9. Vary the engine RPM slightly with the throttle to aid in warm-up until the
engine idles smoothly.
10.Release the parking brake before driving.
STOPPING THE ENGINE
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in neutral.
3. Set the parking brake.
4. Stop the engine.
5. Turn key to off position
34
