COMMANDER
INSTALLATION MANUAL
22
Figure 6.7:
Active Cycles
Electrical Installation
Setting the Car Wash Cycle Synchronization
The Car Wash Cycle Synchronization is a programmable setting in the Commander controller. The proper
setting of this category depends on the equipment used in your car wash system.
If the car wash equipment normally leaves the CYCLE/INHIBIT RELAY de-energized while in standby, and then
energizes the relay when the customer enters the bay, the programming category should be set to PASSIVE.
If the reverse occurs, where the car wash equipment normally energizes the CYCLE/INHIBIT RELAY while in
standby, then de-energizes the relay when the customer enters the bay, the programming category should
be set to ACTIVE.
Figure 6.6:
Passive Cycles
