HAMAR LASER STEALTH Series, Общее руководство по обучению

Страница: 10 / 113

6
The L-732 Dual Scan® Precision Roll Alignment Laser
Primarily designed for roll alignment and other similar
alignment applications that do not require the exacting
tolerances of the L-742 Ultra-Precision Dual Scan
®
Laser,
the L-732 Precision Dual Scan
®
Laser also offers 2
automatically rotating laser planes that can be configured at
the factory to have either 2 vertical planes (typically used for
roll alignment), or 1 horizontal and 1 vertical laser plane.
Using the L-732 you can quickly and easily check and
correct horizontal roll parallelism of even the tallest process
mills, pick up and check offset centerline benchmarks, and
perform similar alignments with increased accuracy and
shorter setup times.
Applications: (for alignments with tolerances of .00015 in/ft or (0.01 mm/m) or greater
•
Normal or blown-film lines (roll alignment)
•
Rubber (roll alignment)
•
Leveling almost any surface (squares, frames,
ways, flanges, circles, etc.
•
Laser cutting machines
•
Water-jet cutting machines
•
Checking plumb of a vertical surface up to 100
ft. (30.5 m)
•
Steel (roll alignment)
•
Sawmills
•
Checking way twist and parallelism between
vertical surfaces
•
Textiles (roll alignment)
Measuring and aligning:
•
The flatness of almost any vertical surface
(squares, frames, ways, flanges, circles, etc.)
•
The straightness of horizontally and vertically
traversing axes
•
The parallelism of vertical or horizontal surfaces,
even if those surfaces are 100 ft. (30.5 m) apart
•
Measuring surfaces up to 200 ft. (61 m) long with
one setup
•
The squareness of any two vertical surfaces
•
The flatness and straightness of vertical
surfaces
Features
•
Continuously rotating laser planes with
operational range of 100 ft. (33 m) in radius.
•
Laser planes flat to 2.0 arc seconds in 180º
sweep and 1.0 arc-second in 90º sweep.
•
Standard target: A-1519-2.4ZB Single-Axis Wireless
Target with 0.5 micron (.000002 in.) resolution
• Standard levels are accurate to 2 arc second (.00012
in/ft or 0.01 mm/m).
•
Split-Prism Upgrade Levels are accurate to 1 arc
second (.00006 in/ft or 0.005 mm/m).
• System uses Windows-based software for quickly
recording and analyzing machine geometry data
•
Typical setup time 20 minutes or less
•
Top-to-Back Laser Planes are square to 2 arc sec
(.00012 in/ft or 0.01mm/m).
•
Side-to-Back Laser Planes are square to 3 arc
sec (.00018 in/ft or 0.015mm/m).
•
Includes Pitch/Roll/Yaw base with fine and
medium-resolution adjustments and lighted
levels.
•
M-124-LiPo 9V Lithium Polymer Rechargeable
Battery Pack or 110-240V A/C 9V Adapter