Hamamatsu Energetiq LDTLS TLS-EQ-9, Руководство по эксплуатации

Страница: 18 / 31

13
2. Run "setup.exe" and follow the prompts to install the application.
3. Connect the monochromator to the host PC USB port.
4. Run "MH1034App.exe" to launch the application.
The Windows .dll installed by the installer can also be used to write custom control software. Refer to the
document "MH1034 Mono DLL Description Jul-28-2016.pdf" for a description of the software interface.
5.4. Changing Monochromator slits
The monochromator of the TLS-EQ-9 comes standard with 1mm wide entrance and exit slits installed.
The 1mm slit width was chosen to provide an optimal combination of narrow band width and high flux
throughput. An optional monochromator slit kit with several alternative pairs of slits (0.1mm, 0.25mm, and
0.5mm) is available. To change the slits, slide the installed slit upward to remove it from the
monochromator as shown below in Figure 5. To install, slide the slit into the same location. The
monochromator is designed to be operated with the same width slit in the entrance and exit apertures.
The slits must be replaced in pairs of the same width.
Figure 5: Replacement of Monochromator Slit
(exit aperture shown)
6. Service Requirements
There are no user-serviceable parts inside the TLS-EQ-9. For any problems encountered during operation,
please contact Energetiq Technology for assistance.
If there is a component failure, do not attempt to open the Controller or Lamp enclosure of the TLS-
EQ-9.
Any service to the system must be performed only by factory authorized and trained technicians. To avoid
injury, under no circumstances should the user open or modify the Lamp or Controller enclosure.