Hamamatsu Photonics C9525 SERIES, Инструкция по эксплуатации

Страница: 16 / 35

@X4-0047-5
－ 16 －
■
To read the currently set values
Click the UPDATE button to read and display the currently set values.
■
To reset
Click the SET button to return to the same state as when the power was turned
on. (This enters Local mode that also allows panel key operation.)
■
To control the high voltage output
Click the ON/OFF button to turn on or off the high voltage output that was set.
■
To read, write, or erase the setting (flash memory)
Any setting can be stored in a flash memory (0 to 5).
Memory # 0 is selected at the time of startup. High voltage can
also be output (ON) at startup.
Select the desired memory # and click the READ or WRITE or
ERASE button as needed.
To erase the settings stored in all memories, select “A” and click the ERASE button.
■
To read the information
Click the “Read Inf.” button to read Type No. , Serial No. and Firmware Revision.
The information is shown in the Response box.
■
To display the command log
Click the ON button to display the send/receive commands used to make various settings. You
may refer to this log when creating control commands on your own. Press the OFF button to
hide the log.
■
To search for the VCP number used for USB
Click the SEARCH button to search for the VCP number.
This function is available on Windows 2000 or later versions.
If your PC uses an earlier Windows version, enter the VCP number.
■
To quit the program (QUIT)
Click the QUIT button to reset and exit the control program.
Remote mode will not be released if the program was terminated without
using this QUIT button. To next use the C9525 in Local mode, use the panel
keys to enter Local mode (See below).
■
To display the help screen (HELP)
Click the HELP button to display the Help screen.
You can refer to the instructions in Help on how to use this program and
control command list.