C9300-201 Ver.1.2
HAMAMATSU PHOTONICS K.K.
29
(5) Status commands
When the host computer outputs a status command, the camera then returns a
response. All status commands are precedes by a question mark (“?”); if the status
command is contained within a setting command, the question mark is added at the
beginning of the command.
?AMD
Returns the setting the camera mode in the CCD exposure start timing.
?NMD
Returns the setting for the method used to set the exposure time when the
exposure timing is controlled internally.
?EMD
Returns the setting the method used to set the exposure time when the
exposure start timing is External control mode.
?SMD
Returns the setting the scan mode.
?ADS
Returns the setting the digital data output bit count.
?TNS
Returns the setting the CCD output mode.
?SHT
Returns the exposure time when the exposure trigger timing is controlled
internally.
?EST
Returns the exposure time when the exposure trigger timing is controlled
externally.
?AET
Returns the setting of exposure time.
?ATP
Returns the external trigger pulse polarity.
?SPX
Returns the setting of the binning count.
?SVO
Returns the setting value for the vertical start address.
?SVW
Returns the setting value for the vertical line width.
?SLP
Returns the setting value for the readout line.
?ESC
Returns the setting the input connector for external control pulse.
?CEG
Returns the setting value the contrast enhancement gain.
?RES
Returns the setting for the command response.
?VER
Returns the version of the camera’s internal components.
?INF
Returns the information of the camera’s internal components.
?CAI
Returns the information about the camera hardware.
