Connection using the cable supplied:
Insert the RJ-11 connector of the supplied cable into
the RJ-11 terminal on the base of the RB-10 and lay the
cable carefully in the cable guide of the RB-10. Now
insert the TAE-N connector into the left terminal of your
TAE connection socket.
Connection to screw clamps:
Remove the cover of the cable leadthrough carefully
using a suitable tool if necessary. You can now route
the cable into the interior of the casing and connect it
to the two screw terminals (see internal view).
IMPORTANT: After the cover has been broken, the RB-
10 can only be used for wall mounting.
Ensure that there are no wires in the wall where the
holes are to be drilled!
Using the drilling template, drill the holes at the requi-
red position on the wall. Now attach the RB-10 to the
wall using the rawl plugs and screws provided.
Tighten the screws carefully to prevent damage to the
casing of the RB-10.
Now press the upper section carefully onto the RB-10.
Ensure that the LED is not damaged and that no
pressure is exerted on it. Tighten the screw and insert
the cover for the screw again.
7. General Notes
This product complies with R&TTE Directives and is
CE-certified.
A warranty is provided as required by law. The unit
must not be opened, modified or damaged by
mechanical means. The RB-10 Ringerbox switch may
only be used for the purpose described here.
The Ringerbox can also be connected to the analog
outputs of an ISDN system.
The cable guides of the RB-10 Ringerbox are not desi-
gned for round cables. Use flat cables only. If neces-
sary, you can shorten the small locking lug of the RJ-11
connector using a suitable pliers.
Please read this manual carefully.
Contact our technical service for support.
8. Troubleshooting
Problem:
My telephone or fax does not ring.
Solution:
Ensure that the cable is securely connected to the
Ringerbox.
If the cable is connected to the TAE socket, the cable
must also be connected to the Ringerbox, otherwise
terminal devices connected in series do not ring!
The cable must audibly click into position on the RB-10.
The TAE cable to the Ringerbox must be 4-pin.
© Böhm-Elektronik 2004 Date: 06-2004 V1.0 Errors excepted;
subject to changes
Screw cover
LED
Lights on ring signal
Sound outlet
Fig. Internal view
Screw terminals
Leadthrough cover,
can be removed if
necessary
5
00020870_71bda 18.07.2005 13:24 Uhr Seite 7
