Hama Big Zapper, Руководство по эксплуатации

Страница: 15 / 66

13
• Where necessary adjust the height of both remotes so that infrared diodes
are properly aligned.
• The distance between the remote controls should be about 3 cm.
ca. 3 cm
ROC1117GRU ORIGINAL
Note
• Do not move the remote controls during the learning procedure.
• Ensure that the room is not lit by fluorescents tubes or low energy
consumption lamps since such light sources could interfere with the copying.
• The 2 remote controls must be at least 1 meter away from any light source.
• During learning mode, if no key is selected for more than 30 seconds, the
learning mode will exit automatically or if no other remote signal is received.
• Each function key will hold only one command. A new command to be
learned will automatically replace the previous one.
• It is not possible to learn any new functions to the TV, STB and Setup key.
7.2 ENTER LEARN MODE
1. Press and hold the [MUTE] and [VOL+] keys for approx. 3 seconds until the
LED will be lit.
2. Enter the code [9] [8] [0], the LED will flash
2 times and then remain on.
3. The Universal Remote Control is now ready to learn new commands.
7.3 LEARNING OF KEYS
1. Press and release the desired key on the original remote control which
you want the command to be learned. The LED at your Universal Remote
Control will flash to confirm that the information has been received.
2. Then press and release the target key on the Universal Remote Control you
want learned.
3. If the LED flashes 3 times and then remain on, the command has been
learned successfully.
4. Repeat these steps to learn other key functions.
5. Please press the [SETUP] key to save the code and exit learning mode.
Note
While replacing the batteries, the remote control will keep the functions of the
learned keys.
7.4 CLEARING OF LEARNED KEYS
7.4.1 CLEARING OF ONE LEARNED KEY
1. Press and hold [MUTE] and [VOL+] keys for 3 seconds until the LED will be
lit.
2. Enter the code [9] [8] [1], the LED will flash
2 times and then remain on.
3. Press and release the desired key at the Universal Remote Control which
you want to clear the learned command. If the LED flashes 3 times, the
learned command has been cleared successfully.
BIG ZAPPER