Hama Big Zapper, Руководство по эксплуатации

Страница: 13 / 66

11
5.2.5 Press MUTE to save the code and exit the code search. The LED indicator
turns off.
Note
• Internal memory limitations allow only up to 350 most common device codes to
be preloaded. Due to the extensive number of different available TV/STB devices
on the market, it may be possible that only the most common main functions are
available. If so, repeat steps 5.2.1 to 5.2.5 to find a more compatible code. No
code may be available for some special device models.
5.3 Auto Code Search
Auto Code Search uses the same preloaded codes as the Manual Code
Search (5.2) but your Universal Remote Control scanns through the codes
automatically until the device you want to control shows a reaction. This might
be that the device you want to control switches off (POWER key) or changes
the channel (CH+/CH- keys).
5.3.1 Turn on the device you want to control
5.3.2 Press the SETUP key until the LED indicator is permanently lit.
5.3.3 Select the device you want to control using the device key (e.g. TV). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.3.4 Press the CH+/CH- keys or POWER to start the Auto Code Search. The
LED indicator flashes once followed by permanent light. The Universal
Remote Control has a latency of 6 seconds before the first scan starts.
Note: Scan Speed Settings
• Scan Speed Settings can be set at either 1 or 3 seconds. The default setting
for the scan time per single code is 1 sec. If this feels uncomfortable , you
can switch to 3 sec. scan time per single code. To switch between the scan
times, press CH+ or CH- during the
6 sec. latency before Auto Code Search starts scanning.
5.3.5 The LED indicator confirms each single code scan with a single flash.
5.3.6 Press MUTE to save the code and exit the code search. The LED indicator
turns off.
5.3.7 To stop the Auto Code Search during the scan process, press the EXIT
key.
Note
• When all codes are searched without success, the Universal Remote Control
exits Auto Code Search and returns to operational mode automatically.
Currently stored code is not changed.
5.4 Code Identification
The Code identification offers you the possibility, to determine an already
entered code.
5.4.1 Press the SETUP key until the LED indicator is permanently lit.
5.4.2 Select the device you want to control using the device key (e.g. TV). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.4.3 Press SETUP key. The LED indicator flashes once followed by permanent
light.
5.4.4 To find the first digit, press the numeric keys from 0 to 9. The LED indica-
tor flashes once to indicate the first digit of the 4-digit code number.
5.4.5 Repeat step 5.4.4 for the second, third and fourth digit.