6
Note – Faulty transfer of measured
values
•
In isolated cases, interference - e.g. from a WLAN
network, a computer or a television set - can
cause the transfer of measured values between the
measuring station and the base station to fail.
•
In this case, you must resynchronise the stations by
briefly removing the batteries from both stations and
reinserting them.
•
If the measured values are not transferred again once
the batteries are inserted, replace the batteries with
new ones.
•
If necessary, select a new location for the base station
in order to avoid possible interference in the future.
6.2 Selecting the channel/other measuring stations
Note
•
You can install two more measuring stations in
addition to the included measuring station. Ensure
that the base and measuring stations are set to the
same channel.
•
Suitable measuring stations can be found at
www.hama.com
•
Press the button (E) repeatedly to set the channel to
that set on the respective measuring station. Channel 1,
2 or 3 is displayed.
•
If the
symbol is displayed, the weather station will
automatically switch the displayed channel every five
seconds.
6.3 Basic and manual settings
Automatic setting using the DCF signal
•
After the first time the base station is switched on
and successful transmission is established between
the base station and the measuring station, the clock
will automatically search for a DCF signal. During the
search, the wireless symbol (7) will flash.
Display
Searching for the DCF
signal
Display flashing
Active
Displayed continuously
Successful – signal is being
received
No display
Inactive
•
If the station still does not receive a signal, press and
hold the
button (C) for approx. 3 seconds to start
the manual search for the DCF signal. The wireless
symbol (7) will start to flash.
Note – Time settings
•
The search process takes about 7 minutes. If the search
fails, it ends and is repeated at the next clock hour.
•
In the meantime you can, however, set the time and the
date manually.
•
The clock automatically continues to search for the DCF
signal on a daily basis (between 1:00 a.m. and 5:00
a.m.). If the signal is received successfully, the manually
set time and date are overwritten.
•
Press and hold the
button (C) again for
approximately 3 seconds to stop the manual search.
Note – Summer time
The clock automatically switches to summer time.
S
appears on the display as long as summer time is
activated.
(Manual) settings
•
Press and hold the
button (A) for approximately 3
seconds to make the following settings one after the
other:
•
Year
•
Month and date display
•
Month
•
Day
•
Hour
