Hama 00 126851, Руководство по эксплуатации

Страница: 7 / 45

9
• Connect the unused plug on the USB cable to an
available USB port on your computer or another suitable
USB charger. Please refer to the operating instructions for
the USB charger used.
• The LED indicator of the USB charging plug is lit red
during charging. When the battery is fully charged, the
LED indicator goes out.
• Remove the connection cable from the battery bay (4) of
the drone.
• Connect the charged battery to the connection cable.
• Put the connected battery back into the battery bay (4)
and then close the battery compartment cover.
Warning – rechargeable battery
• Only use suitable charging devices with USB
connections for charging.
• As a rule, do not use charging devices or USB
connections that are defective and do not try to repair
them yourself.
• Do not overcharge the product or allow the battery to
completely discharge.
• Avoid storing, charging or using batteries in extreme
temperatures.
• When stored over a long period of time, batteries
should be charged regularly (at least every three
months).
• After every flight and before charging, allow the
motors and the battery to completely cool!
• Continually monitor charging!
• Stop charging immediately if the battery becomes hot
and/or deformed!
• Use a heat-resistant, fire-proof surface for charging!
Note – charging/battery capacity
• It takes approximately 1 hours to fully charge the
battery.
• The battery comes partially charged. Initial charging
may therefore take less time.
• After a charging time of 60 minutes, the flying time is
approximately 8-10 minutes.
• The actual flying time varies according to use of the
product, the settings and ambient conditions (for
example, temperatures below 5°C and above 25°C
reduce battery capacity).
7. Flight mode
7.1 Pairing the drone with the remote control
•
Place the drone on a level surface.
• Move the slide switch (7) on the drone to the ON
position. The LEDs (5) begin to flash.
• Press the on/off switch (12) to switch on the remote
control.
• Move the left control lever (2) all the way up.
• Then move the left control lever (2) all the way down.
• Two signal tones are emitted to confirm the pairing. The
drone’s LED indicator (5) and that of the remote control
(12) are now permanently lit.
7.2 Flight control
Note
• Control the drone only with minimal movements
of the control levers so as to ensure smooth flight
behaviour.
• Avoid jerky movements. The drone could get out of
control.
• The direction specifications assume that the drone
is in front of you and facing forward, or is in Actual
Direction mode (see Section 7.4)