5
5.2 Direct code entry
A code list is included in the universal remote control's
extent of delivery. The code list contains four-digit codes for
setting the remote control to work with most AV equipment
manufacturers.
For easy orientation, the codes are sorted first by type
of device (TV, STB, etc.) and within the type of device
alphabetically by brand name.
Note
This remote control does not have a separate numeric
keypad, so the numbers are assigned to the following
keys. (See Fig.2)
1. Switch the device you wish to operate on.
2. Press and hold the Setup button for approx. 3 seconds
until the LED lights up to start Setup mode.
3. Enter one of the 5-digit codes from the enclosed code list.
The LED flashes briefly as each number is entered.
4. If a valid code is entered, the LED goes out after the 5th
number is entered and the code is automatically saved.
5. Then test the remote control and check whether the
desired functions can be controlled. It is possible that the
first code found is not the most suitable, and possibly not
all functions are available. In this case, repeat steps 2 – 5.
Note
•
If an invalid code is entered, the LED flashes 6 times
and then lights up permanently again. In this case,
repeat entering the code (Step 3).
•
If no button is pressed for 35 seconds in Setup mode,
the LED flashes 6 times and goes out. The remote
control exits Setup mode without changing the previous
settings.
•
Setup mode can be ended at any time by pressing the
Setup button.
6. Control of different devices
With this remote control you can control not only TV sets but
also STB devices (Set Top Boxes - e.g. SAT receivers). In the
factory setting, the remote control is preset to control TV sets.
To toggle between the various devices, proceed as follows:
1. Briefly press the Setup button. The LED flashes once.
2. The remote control is now in control mode for STB
devices. Each time the button is pressed, the LED flashes
once.
Return to TV mode:
1. Briefly press the Setup button. The LED flashes 2x.
2. The remote control is now in control mode for TV devices.
Each time the button is pressed, the LED flashes once.
7. Learning function
This remote control is equipped with a learning function. This
allows you to transfer functions from your original remote
control to this universal remote control.
7.1 Before you start the learning function
•
Make sure that all batteries used in both remote controls
are in perfect condition. Change them if necessary.
•
Place your original remote control and the universal
remote control next to each other so that the infrared
diodes of the remote controls are directly opposite each
other.
•
If necessary, correct the height of both remote controls to
achieve optimal alignment.
•
The distance between the two remote controls should be
approx. 3 cm.
ca. 3 cm
ORIGINAL
Nano
se
tup
vol
D
is
ne
y
N
etf
lix
primevi
-
deo
ch
Содержание 00 040070
Страница 3: ......
