Hama 00 040070, Руководство по эксплуатации

Страница: 7 / 112

4
The remote control can control 2 different types of devices,
TV and STB. To switch between device types, press the Setup
button briefly (<3 seconds).
• TV mode:You can select the green or red LED colour for
the TV mode. If you have defined the TV mode with one of
the two colours, the status LED lights up in this LED colour
every time you press the button again.
• STB mode:You can use the respective other LED colour
for STB mode. If you activate the STB mode, the status
LED lights up in this LED colour every time you press the
button again.
5.1 Brand-specific code search
With the brand-specific code search, you can reduce the
search to the codes for the brand of your device. The
following overview shows you which brand is represented
by which button.
For TV sets
Button Brand
BACK Panasonic, TV
HOME Sony, TV
MENU Grundig, TV
REW Toshiba, TV
PLAY/PAUSE Hisense, TV
FF Telefunken, TV
VOL+ TCL, TV
CH+ Samsung, TV
VOL- LG, TV
CH- Philips, TV
(All TV brands)
For Set Top Boxes (STB)
Button Brand
PRIME VIDEO (All STB brands)
1. Switch the device you wish to operate on.
2. Press and hold the Setup button for approx. 3 seconds
until the LED lights up.
3. Press the Power button once. Then press the button
that stands for the brand of your terminal (e.g. BACK for
Panasonic).
4. Point the remote control at the device you wish to control.
5. The remote control now sends a new command to your
device every 2 seconds. The LED flashes once for each
command and then lights up permanently again.
6. As soon as your device switches off, press the OK button to
save the code. The LED goes out.
7. Then test the remote control and check whether the
desired functions can be controlled. It is possible that the
first code found is not the most suitable, and possibly not
all functions are available. In this case, repeat steps 2 – 6.
Note
• If you want to switch to another brand during the
search, simply press the key assigned to that brand
(e.g. >II for Sony). The code search will then continue
for this brand.
• After all codes assigned to a brand have been searched,
the LED flashes 6 times and Setup mode is terminated.
If no suitable code has been found for your device, start
the code search for all brands.
• If no button is pressed for 35 seconds in Setup mode,
the LED flashes 6 times and goes out. The remote
control exits Setup mode without changing the previous
settings.
• Press the Setup button to exit Setup mode.