Page 4
1000004727 (Rev. A - 09/18)
HAC-HB*1C HAC-HB-NF-*1C
HWF3000 WATERSENTRY
®
PLUS FILTER INSTALLATION (With Filter)
WARNINGS:
• Do not use with water that is microbiologically unsafe or of unknown quality. For potable water only.
• Do not use with a hot water supply. Rated for water temperature: 33°-100°F(2°-38°C)
• Water line pressure must not exceed 100 PSI(690kPa). Use an inline water pressure regulator before filter
to limit maximum pressure. Rated water supply pressure: 20-100PSI(138-690kPa).
•
Filter kits must be installed in compliance with all state and local laws and regulations governing the
installation and use of this product.
•
NOTE:
If existing plumbing rough-in locations (Drain, Water In, and Electric Supply) do not allow the filter
to be mounted inside the cooler cabinet the filter can be installed horizontally below the unit. A retrofit kit is
available to mount the filter beneath the cooler.
NOTE:
• Ends of tubing must be cut square and free of
burrs and sharp ends that could cut or nick
the o-rings.
• Loosen the locknut and push tube end past
both o-rings to a positive stop in the filter
head recess - approx. 1".
• Locknut may have to be backed out a little
more. Screw the locknut hand tight to seal.
Attach water-in
copper tube to
Filter Head inlet
2) Attach Filter head assembly.
• If not already preassembled. Attach Filter
head assembly to filter mounting bracket
with four(4) screws supplied.
Single Level Models
Two Level Models
•
Single Level Models
•
Mount with 3/8” inlet on Right Side
• Two Level Models
• Mount with 3/8” Inlet on Left Side
OPERATION OF SUPERSEAL STYLE FITTINGS
1)
Attach port fittings onto Filter Head:
• Note: Refer to photos at left for proper alignment.
•
Insert 3/8” 90° Quick Connect elbow fitting into
Superseal IN port.
• Insert 1/4” poly tube into Superseal OUT port.
If necessary, insert a 1/4” x 90° Elbow.
•
Adjust and tighten port fittings.
B
C
A
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
OPERATION OF QUICK CONNECT FITTINGS
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
RELEASE TUBE
OPERATION OF QUICK CONNECT STYLE FITTINGS
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
A
B
C
