Halma BEA LZR-WIDESCAN, Механическая установка

Страница: 6 / 12

1 2
3
1
2
3
2
3 4
75.0047.01 LZR-WIDESCAN Mechanical Installation 20210726 Page 6 of 12
Before opening the sensor, make sure
the cover is
not locked
(red cover lock).
Be sure to not turn the lock too far,
because the lock can break.
Remove the cover
completely
before
installing the sensor.
Pull the two legs on top in order to open
the cover.
Remove the mounting bracket from the sensor by
twisting CCW until the sensor detaches, and then secure
the bracket to the wall. If using a right-mount position,
the bracket must be positioned at a ~30° angle.
You can also install the sensor directly without using the
mounting bracket (see inset, not recommended).
Verify that the angle lock screw is positioned as
indicated. Unscrew slightly if necessary.
MOUNTING
OPEN THE SENSOR
right mount
center or left mount recommended
UNLOCKED LOCKED
Tilt the sensor on its left side, align the tabs on the
bracket with the notches on the back bracket of
the sensor, and then rotate the sensor CW until the
sensor is securely attached.
Plug in the connector and pass the cable (PN 35.1554)
through the cable passage without making a loop.