71-0149 Hallmark 46 57 SL2 Manual
Date: 12/30/2019
Rev 02
Page 3 of 11
ROOM ASSEMBLY
The Hallmark Series is for Interior Installation Only.
The sauna rooms come in different sizes. These instructions are only for the 4x6 and 5x7 Hallmark Series
rooms.
•
Each panel is heavy. Be careful to avoid injury when installing, especially the top panel.
•
Two adults are required for the installation of sauna room.
•
There is a pin or a slot on the sides of each panel, which will be installed correspondently with one pin
to one slot in the following way when installing:
o
The panel with pin should be lifted about 1 inch (2 cm) higher than the panel with the slot
(Refer to Picture 1).
o
Place the panel with the pin against the panel with the slot (Refer to Picture 2), and then slide
the panel with the pin down until the two panels are equal in height (Refer to Picture 3).
o
If they are not equal in height or there is an obvious gap between the two panels, that means
they are not properly attached, and you should try again.
Typical room installation is as follows:
1.
Place floor/base panel on level surface. If not even, shim the base panel until level
2.
Place back right wall panel on floor/base panel
3.
Place right wall panel on floor/base panel then interlock to back panel
4.
Place left back wall panel on floor/base panel and interlock to right back panel
5.
Place left wall panel on floor/base panel and interlock to back left panel
6.
Place right front wall panel on floor/base panel and interlock with right side wall
7.
Place ceiling on top of all wall panels
8.
Install electrical connections
9.
Install benches
10.
Install glass window and door
Note: The vents must be kept free from any obstruction so proper airflow is maintained in the sauna room. Do
not stack anything in front of the vents or push the room wall with vents up tight to a wall surface.
