71-0149 Hallmark 46 57 SL2 Manual
Date: 12/30/2019
Rev 02
Page 5 of 11
ELECTRICAL / HEATER ASSEMBLY
7.
Place CB Box on the floor for easy access. Remove
the cover to access the electrical connections.
8.
Connect all the quick connections according to
the picture and installation manual into the CB Box.
Note: All the low voltage connections have unique
connectors.
1-
Bluetooth Power (3 pin from wall)
2-
Room Temp Sensor (4 pin from wall)
3-
High Limit (2 pin from heater)
4-
Control (RJ 11 from wall)
5-
Lights (RJ 45 from wall)
9.
Lay the heater on its back and remove the two #8 screws on the lower side of
the heater to remove the lower portion of the heater. (save screws for re-
installation)
10.
Install the strain relief clamp as shown, about 2.5” from the end of the black
rubber insulation. Remove the retaining nut for later installation in heater.
Tighten the two clamp screws securely so that the strain relief does not slide on
the cable.
11.
Insert the cable into the open hole on the bottom of the electrical enclosure and
secure using the retaining nut from the first step. Tighten nut to prevent the
strain relief from moving.
12.
Insert the black, white and green wires into the terminal block as shown.
Tighten the screws securely (approximately 18 in/lbs.)
Green = ground
White = Terminal 2 (hot)
Black = Terminal 4 (hot)
1
2
3
4
5
Remove Screws
