46
9
Maintenance
9.1
Safety measures during maintenance work
Carry out the prescribed maintenance work such as cleaning, lubricating, servicing and
inspection on time.
Observe the maximum permissible load cycles (see "3.3 Technical data") and make the
Positioning clamping pin unusable and dispose of them as soon as the maximums are
reached. This applies even if no external wear is visible.
Note the following points before carrying out the maintenance work:
–
Cordon off access to the work area of the Positioning clamping pin. Make sure that no
unauthorised persons are in the work area of the Positioning clamping pin.
–
Make sure that all components have cooled down to ambient temperature.
–
Only carry out work on low-mounted components in a squatting position, not in a bent
position. Carry out work on components mounted high up in an upright, straight
posture.
–
Immediately replace all Positioning clamping pin that are not in perfect working order.
–
Only use original spare parts.
–
Make sure that suitable collection containers are available for all substances (cleaning
agents or other chemical substances) hazardous to groundwater.
After the servicing work has been completed and before using the Positioning clamping
pin, carry out the following activities:
–
Check all previously loosened screw connections once again for tightness.
–
Check that all previously removed components are properly reinstalled.
–
Make sure that all tools, materials and other equipment used have been removed from
the work area.
–
Clean the area of use. Remove any fluids that may have leaked out and similar
substances.
–
Make sure that all components of the Positioning clamping pin are working properly
again.
