3 Drain hose for fresh water
is used to drain the lye from the
fresh water tank.
Note:
the tank requires rinsing at
regular intervals in order to pre-
clude formation of residues.
Drainage of lye: Unhinge the drain
hose and open the seal. The quan-
tity drained-off can be regulated
by rotation of the seal, which is
completely opened, if required, by
swiveling.
Re-close the seal by rotation to the
stop, and attach the drain hose.
Caution:
The legal regulations and
the local provisions have to be
complied with when discharging
detergents.
Driving with the
Hakomatic B 910
Adjusting the driver seat
The driver seat has to be adjusted
such that the operator is comfortably
seated and the operation elements
are within his reach.
Adjusting the driver seat lengthwise as
follows:
49
Tilt the seat upwards
Unscrew the 4 screws below the
seat and position it adequately, then
tighten screws again
Starting
Unplug battery plug from the char-
ger unit and connect with the
machine.
Before connecting the battery plug
with the machine, switch off the
machine by the key switch.
The operator has to be seated on
the Hakomatic’s driver seat.
Note:
The Hakomatic is equipped
with a protective circuit via a seat
switch. If the operator has left
the seat for 2 seconds, any unit is
switched off and the brush head
and the squeegee lifted.
If the operator sits down again, he
may drive again after restarting the
functions by actuating the key (I/P).
If the seat switch is not actuated
with the machine being ON, the
hourmeter display flashes.
Switch on the key switch
Release parking brake
Slowly depress driving pedal until
the desired speed is attained.
Stopping
Release the pedal and the machine
is slowed down (pedal returns auto-
matically to its initial position)
Note:
The slowing effect may be
increased by actuating the reverse
drive pedal.
Only stop the machine at a slope
for a short time otherwise the motor
may be overheated. The Hakomatic
should be stopped at a slope using
the parking brake.
Actuate the parking brake
Switch off by key switch and with-
draw the key.
Before leaving the machine, withdraw
the key and actuate the parking brake
on principle.
Only drive slowly on wet grounds
especially when driving turns because
of skidding hazard. Slow down when
driving downhill turns because of the
tilting risk.
3 Drain hose for fresh water
is used to drain the lye from the
fresh water tank.
Note:
the tank requires rinsing at
regular intervals in order to pre-
clude formation of residues.
Drainage of lye: Unhinge the drain
hose and open the seal. The quan-
tity drained-off can be regulated
by rotation of the seal, which is
completely opened, if required, by
swiveling.
Re-close the seal by rotation to the
stop, and attach the drain hose.
Caution:
The legal regulations and
the local provisions have to be
complied with when discharging
detergents.
Driving with the
Hakomatic B 910
Adjusting the driver seat
The driver seat has to be adjusted
such that the operator is comfortably
seated and the operation elements
are within his reach.
Adjusting the driver seat lengthwise as
follows:
49
Tilt the seat upwards
Unscrew the 4 screws below the
seat and position it adequately,
then tighten screws again
Starting
Unplug battery plug from the char-
ger unit and connect with the
machine.
Before connecting the battery plug
with the machine, switch off the
machine by the key switch.
The operator has to be seated on
the Hakomatic’s driver seat.
Note:
The Hakomatic is equipped
with a protective circuit via a seat
switch. If the operator has left
the seat for 2 seconds, any unit is
switched off and the brush head
and the squeegee lifted.
If the operator sits down again, he
may drive again after restarting the
functions by actuating the key (I/P).
If the seat switch is not actuated
with the machine being ON, the
hourmeter display flashes.
Switch on the key switch
Release parking brake
Slowly depress driving pedal until
the desired speed is attained.
Stopping
Release the pedal and the machine
is slowed down (pedal returns auto-
matically to its initial position)
Note:
The slowing effect may be
increased by actuating the reverse
drive pedal.
Only stop the machine at a slope
for a short time otherwise the motor
may be overheated. The Hakomatic
should be stopped at a slope using
the parking brake.
Actuate the parking brake
Switch off by key switch and with-
draw the key.
Before leaving the machine, withdraw
the key and actuate the parking brake
on principle.
Only drive slowly on wet grounds
especially when driving turns because
of skidding hazard. Slow down when
driving downhill turns because of the
tilting risk.
3 Drain hose for fresh water
is used to drain the lye from the
fresh water tank.
Note:
the tank requires rinsing at
regular intervals in order to pre-
clude formation of residues.
Drainage of lye: Unhinge the drain
hose and open the seal. The quan-
tity drained-off can be regulated
by rotation of the seal, which is
completely opened, if required, by
swiveling.
Re-close the seal by rotation to the
stop, and attach the drain hose.
Caution:
The legal regulations and
the local provisions have to be
complied with when discharging
detergents.
Driving with the
Hakomatic B 910
Adjusting the driver seat
The driver seat has to be adjusted
such that the operator is comfortably
seated and the operation elements
are within his reach.
Adjusting the driver seat lengthwise as
follows:
49
Tilt the seat upwards
Unscrew the 4 screws below the
seat and position it adequately, then
tighten screws again
Starting
Unplug battery plug from the char-
ger unit and connect with the
machine.
Before connecting the battery plug
with the machine, switch off the
machine by the key switch.
The operator has to be seated on
the Hakomatic’s driver seat.
Note:
The Hakomatic is equipped
with a protective circuit via a seat
switch. If the operator has left
the seat for 2 seconds, any unit is
switched off and the brush head
and the squeegee lifted.
If the operator sits down again, he
may drive again after restarting the
functions by actuating the key (I/P).
If the seat switch is not actuated
with the machine being ON, the
hourmeter display flashes.
Switch on the key switch
Release parking brake
Slowly depress driving pedal until
the desired speed is attained.
Stopping
Release the pedal and the machine
is slowed down (pedal returns auto-
matically to its initial position)
Note:
The slowing effect may be
increased by actuating the reverse
drive pedal.
Only stop the machine at a slope
for a short time otherwise the motor
may be overheated. The Hakomatic
should be stopped at a slope using
the parking brake.
Actuate the parking brake
Switch off by key switch and with-
draw the key.
Before leaving the machine, withdraw
the key and actuate the parking brake
on principle.
Only drive slowly on wet grounds
especially when driving turns because
of skidding hazard. Slow down when
driving downhill turns because of the
tilting risk.
3 Drain hose for fresh water
is used to drain the lye from the
fresh water tank.
Note:
the tank requires rinsing at
regular intervals in order to pre-
clude formation of residues.
Drainage of lye: Unhinge the drain
hose and open the seal. The quan-
tity drained-off can be regulated
by rotation of the seal, which is
completely opened, if required, by
swiveling.
Re-close the seal by rotation to the
stop, and attach the drain hose.
Caution:
The legal regulations and
the local provisions have to be
complied with when discharging
detergents.
Driving with the
Hakomatic B 910
Adjusting the driver seat
The driver seat has to be adjusted
such that the operator is comfortably
seated and the operation elements
are within his reach.
Adjusting the driver seat lengthwise as
follows:
49
Tilt the seat upwards
Unscrew the 4 screws below the
seat and position it adequately,
then tighten screws again
Starting
Unplug battery plug from the char-
ger unit and connect with the
machine.
Before connecting the battery plug
with the machine, switch off the
machine by the key switch.
The operator has to be seated on
the Hakomatic’s driver seat.
Note:
The Hakomatic is equipped
with a protective circuit via a seat
switch. If the operator has left
the seat for 2 seconds, any unit is
switched off and the brush head
and the squeegee lifted.
If the operator sits down again, he
may drive again after restarting the
functions by actuating the key (I/P).
If the seat switch is not actuated
with the machine being ON, the
hourmeter display flashes.
Switch on the key switch
Release parking brake
Slowly depress driving pedal until
the desired speed is attained.
Stopping
Release the pedal and the machine
is slowed down (pedal returns auto-
matically to its initial position)
Note:
The slowing effect may be
increased by actuating the reverse
drive pedal.
Only stop the machine at a slope
for a short time otherwise the motor
may be overheated. The Hakomatic
should be stopped at a slope using
the parking brake.
Actuate the parking brake
Switch off by key switch and with-
draw the key.
Before leaving the machine, withdraw
the key and actuate the parking brake
on principle.
Only drive slowly on wet grounds
especially when driving turns because
of skidding hazard. Slow down when
driving downhill turns because of the
tilting risk.
Содержание Hakomatic B910 (7744)
Страница 1: ...Instruction Manual Hakomatic B910 7744...
