![background image](http://html1.mh-extra.com/html/hakko-electronics/fu-601/fu-601_instruction-manual_3337753008.webp)
7
16
4. Place the HAKKO FU-6002 on the iron unit fixing assembly and tighten the two screws.
●
How to position the tip after replacement
After replacement, you need to position the tip.
Loosen the positioning screw and align the tip with the reference point set in the previous page.
To prevent the upward movement and misalignment of the tip, tighten the screws while pressing
the tip from the top.
●
Installing the iron to the feeder unit
Tighten the feeder unit set screws as shown in the figure below.
Now you can install the HAKKO FU-6002 to the feeder unit.
●
The HAKKO FU-6002 maintenance
After the HAKKO FU-6002 is used for soldering, the unit (particularly the flux protector) is
heavily deposited with flux.
If you insert a tip into the unit with flux deposit in or around the hole of the flux protector,
the flux may be entrained into the hole and deposit on the terminal of the HAKKO FU-6002,
causing poor contact (sensor error).
Regulary wipe off the flux using alcohol.
If wiping the flux protector did not remove the flux or dirt or the flux protector was deformed,
replace it.
Flux protector
Part No.
:
BX1027
CAUTION
NEVER use thinner or other solvent to wipe the unit and the flux protector.
Doing so may melt the resin part.
Positioning screw
②
5. Inspecting and cleaning the tip
This procedure, if followed daily, will materially add to tip life.
a. Set the temperature to 250℃ (482℉).
b. When the temperature stabilizes, clean the tip and check the condition of the tip.
If the tip is badly worn or deformed, replace it.
c. If the solder plated part of the tip is covered with black oxide, apply fresh solder, containing flux,
and clean the tip again. Repeat until all the oxide is removed, then coat the tip with fresh solder.
d. Turn the power OFF and remove the tip, using the heat resist pad. Set the tip aside to cool.
Remaining oxides can be removed with isopropyl alcohol.
CAUTION
NEVER file or use abrasive materials on the tip to remove oxides!
Tighten
size
:
M3×30
Positioning screw
①
Positioning screw
②