![background image](http://html1.mh-extra.com/html/hakko-electronics/fu-601/fu-601_instruction-manual_3337753003.webp)
21
2
12. DIMENSIONAL OUTLINE DRAWING
3. WARNINGS, CAUTIONS AND NOTES
Warnings and cautions are placed at critical points in this manual to direct the operator’s
attention to significant items. They are defined as follows:
WARNING
:
Failure to comply with a WARNING may result in serious injury or death.
CAUTION
:
Failure to comply with a CAUTION may result in injury to the operator, or
damage to the items involved. Two examples are given below.
WARNING
When power is ON, tip temperatures will be between 50 and 500℃. (120 to 940℉)
To avoid injury or damage to personnel and items in the work area, observe the
following:
●
Do not touch the tip or the metal parts near the tip.
●
Do not allow the tip to come close to, or touch, flammable materials.
●
Inform others in the area that the unit is hot and should not be touched.
●
Turn the power off when not in use, or left unattended.
●
Turn the power off when changing parts or storing the HAKKO FU-601.
●
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
●
Children should be supervised to ensure that they do not play with the appliance.
●
The unit is for a counter or workbench use only.
●
To prevent accidents or damage to the HAKKO FU-601, be sure to observe the following.
CAUTION
●
Do not use the HAKKO FU-601 for applications other than soldering.
●
Do not give an excessive shock to the iron.
●
Remove power and iron cords by holding the plug. not the wires.
●
Do not modify the HAKKO FU-601.
●
Use only genuine Hakko replacement parts.
●
Do not allow the HAKKO FU-601 to become wet, or use it with wet hands.
●
Be sure the work area is well ventilated. Soldering produces smoke.
●
Be sure the cooling fan at the rear of the station is unrestricted.
●
While using the HAKKO FU-601, don’t do anything which may cause bodily harm or
physical damage.
※
1
The dimension can be adjusted in range of ±5mm.
※
3
When the tip using a long.
HAKKO FU-6001/6002
disconnected
HAKKO FU-6001
connected to the feeder unit
HAKKO FU-6002
connected to the feeder unit
A
29
32
(108)
71
40
47
40
47
71
89
18
29
A
※
1
104 (※
3
108)
70
56
7
30
Back view of A
Back view of A’
2 mounting holes
Φ4.2 Through
Φ8 Counterbore
5 Deep