6
5. OPERATION
S button
START/STOP button
CAUTION
When not in use, place the handpiece on the holder.
C. Electrical connection and power ON
1. Insert the power cord into the receptacle on
the rear panel of the station.
2. Place the handpiece on the holder.
3. Plug the other end of the power cord into
a grounded wall socket.
4. Turn the power switch ON.
CAUTION
This product is protected against electrostatic
discharge. Be sure the unit is grounded.
The rim of the
handpiece must
rest on the area
circled in the
illustration.
2. Stop
Press the “S” or button again. Power to the heater is shut off and cooling begins. When the
temperature falls to 200°F (100°C), or after 1.5 minutes of cooling, air blow is automatically stopped. The
display will show indicating that the station is ready to start again.
●
Air Blow
1. Start
Press the “S” button on the handpiece or (START/STOP) button on the station to start blowing air. Hot
air blows out of the tip of the nozzle. Hot air temperature is controlled according to the temperature setting.
●
Setting of the air flow
Pressing the AIR button in the station causes the LED for AIR display to blink and allows
you to change air flow. The air flow setting range is 1 to 9.
Actual airflow may be affected by the size and shape of the nozzle(s) used.
Example:
Changing the air flow setting from 5 to 7
Finished
Press the
button.
Press the
button twice.
Press the or
button.
WARNING
Do not stop the hot air by turning the power switch OFF.
If power is turned off after use, there will be no cool-down. To avoid damage to the equipment, do not turn
the power switch OFF until appears on the display.
