Hakko Electronics FR-811, Инструкция по эксплуатации

Страница: 17 / 48

16
①
RENAME (Input profile name.)
②
TIMER MODE (Change of countdown method.)
Timer mode setting can be switched between the Opened timing and the Closed timing modes.
③
COMMENT (Input comment.)
Up to 10 characters can be input for the profile name. The characters that can be input are
ASCII characters (without “.” ). If you select the " " all following characters will disappear.
Up to 100 characters can be input for the profile name. The characters that can be input are
ASCII characters (without “.” ). If you select the " " all following characters will disappear.
④
PRE ZONE SET (Setting bottom heater settings.)
The various settings of the bottom heater can be performed.
First, select whether the bottom heater function will be ON or OFF.
When ON is selected, the following settings can be performed.
・When ON is selected:
OPE MODE
When POWER mode is selected: ※1
POWER setting
Select POWER mode or T/C mode.
Output power setting
（
001 to 100
％）
Time to transition to the next zone
（
001
〜
999s
）
TIMER setting
When T/C mode is selected:
RAMP RATE setting
Temperature rise rate setting
("--"
※2
, 02 to 20 ℉ /s)
Heating temperature setting (120 to 480 ℉ )
TEMP setting
※1 When selecting the POWER mode, the setting of the START TMG (refer to page 14) is disabled.
※2
When "--" is set, the ramp rate is not controlled and normal electrical power is applied.
When selecting the AUTO mode, bottom heater will operate until the profile is completed.