Hakko Electronics FR-811, Инструкция по эксплуатации

Страница: 12 / 48

11
M A N U
T O P S E T
T C L I N K
R A M P R A T E
E x i t
T O P
- -
º
F
／
S
T O P B T M
・
Sensor selection (Select TOP or PART)
・
RAMP RATE (rate of temperature rise) setting
The ramp rate of the startup temperature can be set to between 2
℉ and 20 ℉ (per second).
②Various settings of hot air (handpiece) heater
M A N U
M O D E C H A N G E
T O P S E T
U S B M E M O R Y
E x i t
T O P B T M
①
Changing modes (MANUAL or AUTO)
②
Various settings of hot air (handpiece) heater
To top screen
Saving profile stored in the station to a USB memory device.
Reading profile stored in a USB memory device into station.
(Not used in MANUAL mode.)
Select TOP. Select PART.
T/C connector
Circuit
board side
Thermocouple
Perform control using
thermocouple sensor.
M A N U
T O P S E T
T C L I N K
R A M P R A T E
E x i t
T O P
0 0
º
F
／
S
T O P B T M
CAUTION
Restrictions created by various nozzles may reduce the rate of temperature rise.
In the menu screen, turning the operation knob left or right will move the cursor. If you move the cursor
to the desired item and press the center of the operation knob, you can perform the settings for each item.
1. Menu screen
①Changing modes
Refer to the "
●
Mode selection" in page 9.
Perform control
using handpiece sensor.
Sensor
(inside)
Note:
When "--" is set, the ramp rate is not controlled and normal electrical power is applied.
M A N U
T C
T C P
T C B
- - -
º
F
- - -
º
F
BTM
150
º
C
R A M P
- -
º
C ／ S
L
T O P B T M
"L" will be displayed when
"PART" is selected.