3
4. PART NAMES
Heat resistant pad
Plug
Fixing flange
Iron holder
Component bed
Cleaning sponge
Tip
Plug
Cord
Handle
Button
Connecting cable
5. SETTING UP THE FM-2023
1. Connector cord
Pass the connector cord through the hole
in the heat resistant pad.
2. Iron holder
When the iron holder is connected with the
HAKKO FM-203 or FM-206 station by using
a connecting cable, the sleep function can
be used.
Refer to the HAKKO FM-203 instruction
manual for how to set the sleep time.
Detailed information for HAKKO FM-206 on
how to set the sleep time can be found in
manuals available at the HAKKO Document
Portal. Please download and refer to it.
3. Connections
1. Connect the cord assembly of the FM-
2023 to the receptacle of HAKKO FM-
203 or FM-206.
NOTE:
When MODEL FM-2023 is connected to FM-206,
be sure not to connect an incompatible device
because each receptacle connector differs.
2. Place the FM-2023 in the iron holder.
3. Plug the power cord into the power
supply. Be sure to ground the unit.
Push the plug in as far as
it will go, and try to remove it
without pressing the release pin.
If it stays in the receptacle
it is properly seated.
Receptacle
When the plug ‘clicks’,
it is fully inserted.
NOTE:
This product is protected against electrostatic
discharge and must be grounded for full ef-
ficiency.
中継コード
Connecting cable
