3
4. PART NAMES
Iron receptacle
Large cleaning
sponge
Small cleaning
sponge
Cord assembly
Iron holder base
Membrane sheet
Power switch
CAL pot plug/calibrator
Card
5. SETTING UP & OPERATING THE HAKKO 937
CAUTION : The sponge is compressed. It will swell when moistened with water.
Before using the unit, dampen the sponge with the water and squeeze it dry.
Failure to do so may result in damage to the soldering tip.
A. Iron holder
1. Small cleaning sponge
Dampen the small cleaning sponge
with water and then squeeze it dry.
Place it in one of the 4 openings
of the iron holder base.
2. Add water to approximately the
level as shown. The small sponge
will absorb water to keep the larger
sponge above it wet at all times.
*The large sponge may be used alone
(w/o small sponge & water).
3. Dampen the large cleaning sponge
and place it on the iron holder base.
Note: The iron receptacles for the 900
(S) and the 907/908 soldering
irons are different. Be sure to use
the proper one for each type of
soldering iron. (Refer to Parts List).
