Hakki Pilke 50 Easy, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 34 / 38

34
HakkiPilke 50 Easy Version 1.2 2012
12 Failures and remedial measures
Failure Cause Remedial measure
The splitting force is insufficient to
split the wood.
1. The outer check valve of the
acceleration valve is leaking (no. 4).
2. The control valve for the auxiliary
cylinder of the splitting mechanism
(no. 7)
is leaking.
1. Clean or replace the outer
check valve.
2. Clean the pressure
regulating valve of the
control valve or replace
the control valve, as
necessary.
The belt of the input conveyor
does not move. 1. The belt is too loose.
2. The input conveyor's relief
valve is leaking (no. 9).
3. The eye of the optical
measuring device is dirty,
which blocks the ray.
1. Tighten the belt according
to the instructions in
Section 5.4.1.
2. Clean the relief valve or
replace it as necessary.
3. Clean the eye of the
measuring device.
The output conveyor does not
move. 1. The belt is too loose.
2. The output conveyor's relief
valve is leaking (no. 10).
1. Tighten the belt according
to the instructions in
Section 5.4.2.
2. Clean the relief valve or
replace it as necessary.
The cutting motion does not fully
cut the log.
1. The path of the cutting flange is
incorrectly adjusted.
1. Lower the path of cutting
flange.
The blade chain does not properly
sink into the wood. 1. The blade chain is dull.
2. The pressure of the flange's
downward motion is too low.
3. The cutting flange is crooked.
1. Sharpen or replace the
blade chain.
2. Increase the pressure with
the pressure adjustment
screw (Figure 9 of Section
3.2).
3. File the flange.
The machine performs an extra
splitting motion when the splitting
mechanism is operated.
The machine starts but all
functions are inoperable. The
machine makes an abnormal
noise.
1. The electric motor runs in the
wrong direction.
1. See Section 3.2.2.
The electric motor does not start. 1. The emergency stop button is
engaged.
2. The machine makes a loud noise
but does not start.
3. The input cable is faulty.
1. Release the emergency stop
switch.
2. The fuse has burnt. Replace it.
3. Replace the cable.
The motor tends to stop, and the
thermal relay is easily triggered. 1. The blade is dull.
2. The thermal relay is incorrectly
installed.
1. Sharpen the blade.
2. Contact the retailer of the
electric motor.
The splitter makes a whining
sound during sawing or the
splitting of a large log, and the
rotation speed decreases at the
same time. 1. The belts are loose or worn.
1. Tighten or replace the belts.
The cutting blade does not move
downwards.
The splitting groove guard is open. Close the splitting groove guard.