Hakki Pilke 50 Easy, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 24 / 38

24
HakkiPilke 50 Easy Version 1.2 2012
5.1.2. Replacing the blade flange
Replace the blade flange as follows:
1. Remove the blade chain according to
steps 1–6 of Section 5.1.1.
2. Remove the flange bolts (2 x M12), and
detach the fastening plate A on the
other side of the flange.
3. Remove the flange from the groove.
4. Place the new flange against the gear
wheel C, twist it into the groove and
loosely attach the flange bolts and the
fastening plate A.
5. Install and tighten the blade chain
according to steps 7–9 of Section 5.1.1.
Figure 21. Replacing the blade flange
5.2. Splitting mechanism
5.2.1. Operation of the splitting
mechanism
1. Initially, the valve's jointed lever A is in the
middle position, and the spring pushes it to the
right. (Figure 22.)
2. As the cutting blade rises from the bottom
position, the trigger lever B lifts up the trigger
rod C. Once the trigger rod C is up, the spring
presses the jointed lever D to the right, thus
enabling the splitting motion to begin. (Figure
23.)
3. When the trigger rod is close to the splitting
blade, the valve lever E turns to the right,
whereupon the spring pushes the jointed lever
A to the left stopping the splitting motion and
returning the splitting beam. (Figure 24.)
4. When the jointed lever A is on the left, the
trigger lever B and trigger rod C are lowered to
the initial position. (Figure 24.)
5. Once the splitting beam returns to the initial
position, the valve lever E turns to the left and
the spring presses the jointed lever A to the
right. The returned trigger rod C stops the
jointed lever A in the middle position halting
the splitting motion. (Figure 25.)
Figure 22. The splitting mechanism in the
initial position
Figure 23. The triggering of the splitting
mechanism