Hakki Pilke 50 Easy, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 26 / 38

26
HakkiPilke 50 Easy Version 1.2 2012
5.3. Replacing and tightening the V-belts
Replace the V-belts as follows:
1. Shut down the splitter and disconnect it from its power
sources.
2. If necessary, slide the cover of the electrical connector
and angle transmission into a position where the angle
transmission is visible.
3. Remove the belt guard attached to the angle
transmission. (2 x M12)
4. Lift the motor bed B enough to slip out the V-belts A by
first loosening the tightening nuts and, then, turning
the lifting nuts. (4 x M12)
5. Remove the old V-belts (4 pcs).
6. Install the new V-belts.
7. Lower the electric motor far enough to tighten the V-
belts.
The V-belts are at the correct tension when they give
approximately 20 mm when the belt is pressed down at a
moderate force.
5.4. Changing the oil of the
splitter
Change the hydraulic oil of the splitter as follows:
1. Shut down the splitter and disconnect it from its power
sources.
2. Open the filler cap of the hydraulic oil tank (this will
allow the oil to drain more easily).
3. Open the drain hose plug B and drain the oil through
the hose A into a suitable container.
4. Change the filter cartridge for the hydraulics.
5. Tighten the plug B firmly in the hose, and fill the tank
with fresh oil (approx. 125 litres).
6. Finally, ensure that the oil level settles between the
maximum and minimum limits indicated on the
dipstick.
Figure 26. Replacing the V-belts
Figure 27. Changing the oil