Hakki Pilke 50 Easy, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 20 / 38

20
HakkiPilke 50 Easy Version 1.2 2012
4.4.2. Re-splitting or splitting without cutting
1. Raise the guard of the cutting and splitting section.
2. Place the log you want to split in the splitting groove.
3. Close the guard of the cutting and splitting section.
4. Start the splitting process with the activation pedal (G in Figure 19).
As necessary, the above procedure can be used to split wood without cutting it.
4.4.3. Replacing the splitting blade
Exercise extreme caution when handling the blade, and use protective gloves. The blade is sharp and weighs
approx. 85 kilos. Ensure that the lifting winch for the splitting blade has been installed according to Section
2.4.
1. Lower the splitting blade all the way
down, which releases it from the
adjusting joint.
2. Shut down the splitter and disconnect it
from its power source.
3. Open the protective mesh and move
the cover plate A aside.
4. Turn the winch frame onto the splitting
blade, and release wire from the winch.
5. Attach the lifting hook to the lifting
point B.
6. Use the winch to lift up the splitting
blade, and lock the winch reel.
7. Turn the winch so that you can lower
the splitting blade on the ground, next
to the machine.
8. Release the winch lock, and use the
winch to lower the blade.
9. Install a new splitting blade by reversing
the above steps.
Figure 16. Replacing the splitting blade