hs dock
Installation
Order h49 7144.907-333
53
10. Screw the product fixing screws into product 2 and
tighten to the specified tightening torque [see »Screw
tightening torques« chapter].
11. Unfasten and remove any lifting gear that may have
been required.
12. Remove the mounting aid on a vertically suspended
spindle if one was used.
DANGER
Serious injuries caused by projectile workpieces
when the hydraulic ports are connected up incor-
rectly!
The hydraulic ports on product 1 and product 2
must be connected up properly.
Hydraulic ports for »Clamping« of product 1 and
product 2 must be connected together which also
same applies to connection of the »Release« hy-
draulic port.
WARNING
Serious injuries can be caused by escaping media
when seals and damaged / missing!
Replace missing or damaged sealing elements.
Ensure that the sealing elements do not fall out or
get damaged during installation / removal, and
apply a thin coat of grease if necessary.
13. Connect up the hydraulics. For this the hydraulic ports
on product 1 and product 2 must be aligned.
14. Check the face run-out of product 2 on the test surface
for checking product face run-out [ide
ally ≤ 0.01 mm].
