Haier MRV II AV48NMVERA, Руководство для стартапов

Страница: 31 / 40

GRUPAd.o.o.
31
Remote Controller Operation
When in use, direct signal transmission head to
the receiver placed on the indoor unit
36.TIMER ON Display
When operating the remote controller in an area
where electronically controlled lights are installed
or wireless handsets are used, please move closer
to the indoor unit as the function of the remote
controller might be affected by signals emitted by
the above mentioned equipments.
The distance between the remote controller and
the receiver should be max 7m and there should
be no obstacle between them.
Do not throw the remote controller; prevent it
from being damaged.
Battery loading
Confirmation indicator
If no indication is displayed after press ON/OFF
button, reload the batteries.
Clock Set
When unit is started for the first time and after replacing batteries in remote controller,
clock should be adjusted as follows:
1.Press CLOCK button, clock indication of " AM " or " PM " flashes.
2.Press or to set correct time. Each press will increase or decrease 1 min. If
the button is kept pressed, time will increase or decrease quickly.
3.After time setting is confirmed, press "SET" : AM or PM stop flashing, while clock
starts working.Note:AM means morning and PM means afternoon.
FRESH
HIGH/SO TIMER
SET
FILTER
HEALTH
RESET
LOCK
SLEEP MODE
CLOCK
CODE
LIGHT
3
2
1
Loading the battery
Ensure that batteries are correctly placed in the
compartment as required for positive and negative
terminals.
Replacing the battery compartment lid
The battery compartment lid is reinstalled in the reverse
sequence.
Display review
Press the button to see if batteries are properly fitted.
If no display appears, refit the batteries.
Note:
It is recommended that the batteries be removed
from the compartment if the remote controller is not
used for an extended period.
The remote controller is programmed for automatic
test of operation mode after the batteries are replaced.
When the test is conducted, all icons will appear on
the screen and then disappear if the batteries are
properly fitted.
When the display become weak, this display no
power in the battery, please change the battery.
If the remote controller does not operate as designed
after fitting new batteries of the same type, press
the Reset button (marked ) with a pointed article.
Battery loading
Batteries are fitted as follows:
Remove the battery compartment
lid Slightly press and disengage the battery
compartment lid marked with " " and then hold the
remote controller by the upper section and then remove
the battery compartment lid by pressing in the direction
of the arrow as shown in the figure above.
HEAT
Displays when healthy run function is set.
34.LOCK State Display
33.BATTERY Energy Display
Notify the user when it is time to change the batteries.
29.Auxiliary ELECTRICAL HEATING Display
30.HEALTH Display
32.SLEEP State Display
31.Operation MODE Display
35.FAN SPEED Display
A
U
T
O
LOW MID HIGH AUTO
+ -
- +