Haier HWD80-B14939S8, Руководство пользователя

Страница: 27 / 34

EN
10-Installation
27
10.1 Preparation
▶
Take the appliance out of the packaging.
▶
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
10.2 OPTIONAL: Install noise reduction pads
1. When opening the shrink package, you will fi nd
some noise reduction pads.These are used for re-
ducing noise. (Fig. 10-1)
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator.
3. Take out the noise reduction pads and remove
the double-sided adhesive protective film;paste
around the bottom; the noise reduction pads un-
der the w- ashing machine cabinet as shown in
Figure 3.(two longer pads in position 1 and 3, two
shorter pads in position 2 and 4). Finally set the
machine upright again.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
10.3 Dismantle the transportation bolts
The transport protection on the rear side is designed
for clamping anti-vibration components inside the ap-
pliance during transportation to prevent inner dam-
age. All elements (I, R, S and T , Fig 10-2) must be re-
moved before use.
1. Remove all 4 bolts on the rear side and take out
plastic spacers (Fig. 10-2)(Fig. 10-3)
2. Fill left holes with blanking plugs (Fig. 10-4)(Fig.
10-5).
2x
3.
2x
10-1
1.
2.
2.
10-1
10-4 10-5
10-2
10-3