Eng
Lis
H
9
LoCation rEquirEmEnts
• The washer must be installed on a solid floor to minimize vibration during the spin cycle.
• The floor should be level with maximum slope of 1" (25mm) under entire washer.
• A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, cooking appliances, etc.
• Do not install on carpeting.
• The location must have a grounded electrical outlet located within 4ft. (1.2m) of
the power cord on the back of the washer.
• Hot and cold water faucets must be present within 3ft. (0.9m) of the hot and cold
connections on the washer.
• A water heater must supply hot water with a temperature of at least 120ºF (49ºC).
• The water pressure should be between 20-100 psi (138-690 kPa).
• This appliance must be operated at room temperature.
• Do not install or operate this appliance in an area where the ambient temperature
can fall below freezing.
unit DimEnsions anD CLEaranCEs
23-7/16"
Front View
Side View
23-7/16"
41-3/4"
Open
Door 20"
33-3/16"
minimum installation Clearances / Detergent minimum
Alcove
Closet
Front
n/a
1" (25mm)
Sides and Rear
1" (25mm)
1" (25mm)
Top of Control
n/a
n/a
