9-Installation
Following connections are possible:
9.6.1 Drain hose to sink
edge
Protect the U-support sufficiently against slipping.
Hang the drain hose with the U-support over the
of a sink with adequate size (Fig. 9-6.1).
9.6.2 Drain hose to waste water connection
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the waste
Attach the U-support and secure it sufficiently
water pipe.
(Fig. 9-6.2).
9-6.2
9-6.1
9.6 Drain Water Connection
Fix
between 80 and 100 cm above the appliance bottom line! If possible keep always drain hose
fixed to the clip at the appliance back.
the water drain hose properly to the piping. The hose has to reach at one point a height
WARNING!
O
Never reuse old hose sets!
Use only the supplied hose set for the connection.
nly connect to cold water supply.
Before connection, check whether the water is clean and clear.
CAUTION!
D
The Drain hose should not be submerged in water and should be securely fixed
and leak-free. If the drain hose is placed on the ground or if the pipe is at a height
of less than 80 cm, the washing machine will continuously drain while being filled
(self-siphoning).
rain hose is not to be extended. If necessary contact after sales service.
9.6.3 Drain hose to sink connection
The junction must lie above the siphon
.
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc
-
tion (Fig. 9-6.3).
Secure the drain hose with a clamp.
9-6.3
26
Содержание HW80-BP12929
