Haier HW80-B14979, Руководство пользователя, Страница: 25 / 32

EN
10-Installation
25
10.1 Preparation
▶
Take the appliance out of the packaging.
▶
Remove all packaging material including polystyrene base, keep them out of childrens
reach.
▶
While opening the package, water drops may be seen on plastic bag and porthole.
This normal phenomenon results from water tests in the factory.
10.2 OPTIONAL: Install noise reduction pads
1. When opening the shrink package, you will fi nd
some noise reduction pads.These are used for re-
ducing noise. (Fig. 10-1)
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator.
3. Take out the noise reduction pads and remove
the double-sided adhesive protective film;paste
around the bottom;the noise reduction pads
under the w- ashing machine cabinet as shown in
Figure 3.(two longer pads in position 1 and 3, two
shorter pads in position 2 and 4). Finally set the
machine upright again.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
10.3 Dismantle the transportation bolts
The transport protection on the rear side is designed
for clamping anti-vibration components inside the ap-
pliance during transportation to prevent inner dam-
age. All elements (I, R, S and T , Fig 10-2) must be re-
moved before use.
1. Remove all 4 bolts (T1 - T4) (Fig. 10-3).
2x
3.
2x
10-2
I1
R5
R6 R7
R9 R10
S2
S1
R8
T1
T4 T3
T2
10-1
1. 2.
2.
10-1
10-3