SERVICE MANUL
Model No.HLTD500AGW
Issue
Rev.
- 31 -
9-2-4. Use the “AUTOMATIC CYCLES” program
the dryer is drying but the clothes
can’t intensive drying end the program
Troubleshooting:
Check if the lint filter is breathe freely.
Check if the exhaust system is good;
Clean or repair the exhaust system.
N
Connect the wire properly
Y
Check if the wire connecting of the
humidity sensor and PCB is
disconnection;
Y
Replace the broken part.
N
Check if the wire unit or PCB is good .
N
If the
drum seal is loose that
reinstall it; If the drum seal
broken that replace the drum
seal
Check if the drum seal is airproof
N
Y
9-2-3. Press the "Start/Pause" button
once the dryer have no action, the cycle signal will
beep twice.
Error message:Door is not closed .
Troubleshooting:
Confirm that the door is closed
Close the door
Connect the wire properly
Replace the door switch and make
sure wire is connected properly.
Cut off the power. Check if the wire
connecting of the door switc
and PCB is
disconnection
Check if the wire unit is good
Check if the PCB is good.
Well:the resistence is 0
;
Broken: the resistence is infinite
Broken
N
Well
Y
Y
N
Well
Check if the Door switch is good.
Replace the Back-up thermostat and
make sure wire is connected properly.
Broken
Replace the wire unit
N
