Haier HDBL865ATS, Руководство по установке

Страница: 10 / 36

8
WATER SUPPLY REQUIREMENTS
•
The pressure of the water coming from the hot water supply line must be 20-
120 psi (138-862 kPa). The supply line may enter either from the right or left
side, the rear or the floor within the shaded area.
•
The water connection is located on the left front side of the dishwasher. Install
the hot water inlet line, using a 3/8” min. copper tubing water line. Route the line
as shown and extend it forward at least 24” (61 cm) from the rear wall.
NOTE: Routing the water line through the left side of cabinet opening will make
water connection easier.
b
a
c
e
d
4" (10.2 cm)
from cabinet
24" (61 cm)
from wall
3" (7.6 cm)
from floor
a
Hot Water Supply
b
Shutoff Valve
c
11/2" (3.8 cm) Dia. Hole
d
Hot Water Line
e
Cabinet Face
•
The hot water line may either pass through the same hole as the electrical cable
and drain hose, or cut an additional 11/2” (3.8 cm) dia. hole for the water line.
•
If the electrical cord has a three prong grounded plug, it cannot pass through the
same hole as the hot water line and drain hose. You must cut a separate hole for
the electrical cord.
•
Adjust the water heater to a water temperature of 120°F to 150°F (49°C to
65.5°C).