Haier DW12-PFE S, Инструкция по эксплуатации

Страница: 6 / 50

8
How to fill the salt container and the rinse aid dispenser
Salt
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits
will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime
and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
When the low salt indicator “1” lights, you must fill the salt.
Remove the lower rack and then unscrew and remove
the cap from the salt container;
If you are filling the container for the first time, fill it with
water;
Place the end of the funnel (supplied) into the hole and
introduce about 2 kg of salt. It is normal for a small amount
of water to come out of the salt container.
Carefully screw the cap back on.
The salt container must be filled when the "low salt indicator"
(located on the control panel) lights.
T o prevent the formation of rust, load the salt just before
beginning a wash cycle.
Adjusting salt consumption
T he dishwasher is designed to allow for adjusting the amount
of salt consumed based on the hardness of the water used.
This is intended to optimize and customize the level of salt
consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see
figure to the side),
If necessary, rotate the ring in an anticlockwise direction
from the " - " setting towards the " + " sign, based on the
hardness of the water being used.
1
9
It is recommended that adjustments be made in accordance with the following table:
R inse aid
T his product makes dishes sparkle and helps them to dry
without spotting. The dispenser is located on the inside panel
of the door and should be filled after low rinse aid indicator
“ 2 ” lights.
L oading the rinse aid
R egardless of the type of detergent dispenser installed on
your appliance, you must proceed as indicated below when
loading the rinse aid.
To open the dispenser, turn the " 3 " cap in an anti-clock-
wise direction and then pour in the rinse aid, making sure
not to overfill. The amount of rinse aid used for each cycle
can be regulated by turning the " 4" dose adjustor, located
beneath the " 3" cap, with a screwdriver. There are 6 differ-
ent settings; the normal dosage setting is 3.
3
4
2
Water Hardness
Clarke
degrees
º
dH
mmol/l
Selector
position
Salt
c o n s u m p t i o n
(Grams/cycle)
Autonomy
(cycles/2kg)
0 14
Level
1
2
3
4
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage adjus-
tor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor to a lower setting.