8
1. Disassemble all packaging materials, including the base
Take out all packaging materials of product at suitable site, including the base, and dissemble all fi xed
tapes or other fi xtures on the freezer used for transportation safety.
2. Check the accessories shipped with the equipment
Please check the articles inside the bin as per the packing slip, contact the after-sale service in time
in case of any discrepancy.
• For the freezer packed well, it could be moved by forklift or clipping vehicle; if you use the forklift,
please insert the forks under the wooden base of the front or back side of the freezer when there is
a wooden base equipped in the freezer; otherwise, if there is no wooden base, please slightly incline
the freezer (with the inclination no more than 45°), and then insert the fork between the seam; if you
use the clipping vehicle, you should clip the freezer together with the base, and should only clip the
sides of the freezer.
Preparation before Use
3. Select appropriate site for placement
In order to keep the freezer under appropriate condition for ventilation, please place it according to
the requirements as follows:
a. For the freezer, besides 30cm distance kept surrounding to it, 60cm should be kept apart from its
top so as to close the door normally;
b.In order to keep the operation stable, please keep the placing site fl at and solid.
4. Leave the unit stand before powering up
Do not turn on the unit immediately after it is situated on site. Keep the unit standing for 24 hours
before powering up the unit.
17
If you have any questions about the operation of the unit, please refer
to the following fi rst. If an issue persists, contact your after sales offi ce.
Do not maintain and dismantle the freezer by yourself!
Fault
Troubleshooting
The freezer does
not work
Whether the power connection is normal or not
Whether the supply voltage is too low or not
Check whether all the temperature settings are normally
Poor cooling
Whether the ambient temperature is too high?
Whether the external door is closed well or not (the frost between the bin and
the door seal might stop the door being closed tightly)
Whether the temperature setting is correct or not
Whether the freezer is kept away from direct sun shine or not
Whether the freezer is closed to any heat source or not
Whether the rubber hole cover and insulating material for through hole used for
test are in place or not.
Whether too many articles with high temperature are put into the freezer at one
time or not
High noise
Whether the freezer is placed on the solid fl oor or not
Whether the outer shell of freezer contact with anything or not
Whether the freezer is under low-temperature operation status (for it will make
some noise if the temperature within it becomes higher due to overload, which
will be reduced gradually when the temperature becomes lower)
Please check that whether the noise is made by the compressor (the noise
from compressor of low-temperature equipment will be higher than that of home
appliance)
Noise caused by beat (which might be caused by quick cooling shrinkage of
parts within equipment, so the temperature should be reduced gradually other
than sharply reduction within a short time)
FAQ
Содержание DW-60W138
Страница 2: ...25 ...
