Haier DW-60W138, Руководство по эксплуатации

Страница: 13 / 14

14
Test hole
Test hole
• Purpose
1. Relevant test should be carried out by putting the test line in the freezer to test the articles or
environment within it.
2. Balance the pressure in and out of the bin in order to open the door cover easily.
• Use method
1. For any data test, you should only open the end caps of braiding at both terminal of the test hole,
and then put in the test line, and stuff the hole with the end caps, which are made of rubber so that
the test line will not be test line.
2. If the temperature within the bin is too low, the door cover will be diffi cult for open, that is because
the pressure within the bin is too small due to low temperature. At that time, you could open the end
cap at the outer side of test hole in order to reduce the internal pressure, so that the door cover could
be opened.
• The picture above is only a schematic diagram, and the test hole is located at
different site due to different model, so please carry out relevant operation based
on the model you have bought.
• After leading out the measuring line, please stuff the test hole with heat
insulating materials again, otherwise the temperature within the freezer would
stay high, and dew or frost would be condensed surrounding to the outside of
through-hole.
11
Name of parts
Handle Foaming door
Test hole
Lock
Control panle Draning hole
Cabinet